[. . . ] 1 2 3 4 5 6 Bit grease Bit Tool holder cap Tool holder cover Side handle Can be swung 360° on the vertical and secured at any desired position 7 Secures at eight different positions back and forth on the horizontal Clamp nut Loosen Tighten "ON I" button ON OFF 14 15 16 17 18 19 20 21 Adjusting dial Screwdriver Rear cover Screws Brush holder cap Socket wrench Crank cap Hammer grease Due to our continuing programme of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. [. . . ] Important: Always be sure that the tool is switched off and unplugged before installing or removing the bit. Clean the bit shank and apply the bit grease provided to it before installing the bit. After installing, always make sure that the bit is securely held in place by trying to pull it out. 3) To remove the bit, pull the tool holder cover down all the way and pull the bit out. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Whenever carbon brushes must be replaced, they cut out the tool automatically. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. Wipe out the old grease inside and replace with a fresh grease (30 g). To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Centre. The side handle can be swung 360° on the vertical and secured at any desired position. It also secures at eight different positions back and forth on the horizontal. To start the tool, push the "ON I" button on the left side of the tool. [. . . ] EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. Measured sound power level: 95 dB Guaranteed sound power level: 98 dB These sound power levels are measured in accordance with Council Directive, 2000/14/EC. [. . . ]